The Build – Steering column installed

As the team continues on, they now have the firewall plate in for the flaming river steering column, which was slightly modified for the clutch rod. The brand-new steering column is ready to slide into the plate and attach to the dashboard with a single mount.

After the installation, there’s a few loose ends to tie up. The steering shaft needs to connect from the firewall to just past the engine block. In order to do this, the team will need to mount and install a carrier bearing next to the headers and suspension. In order to install the carrier bearing, they’ll have to loosen the suspension and install a bolt long enough to handle the bracket.

steering column

The steering linkage from the steering column is now completely mocked up, and it’s time to mark the set screws, put a dimple in place so that when the screws are set in, they will be locked in place. After the steering linkage is completely where it needs to be, they will put the lock tight on the set screws.

steering linkages

They will then install the stock steering wheel so they have control of steering the car back-and-forth, but just wait until you see the custom steering wheel they had made.

Now that the steering column and linkage is installed, watch as The Build team continues to restore the’65  Malibu restomod.  Watch the other episodes on our YouTube channel, and stay up-to-date with the progress of our classic car on our Facebook page too!